How To Properly Remove Paint Transfers From Your Automobile
It’s been staring you in the face now for weeks. Taunting you every time you walk past your car. Those unsightly red marks on your nice white bumper that just showed up one day when you went to the grocery store. No matter how hard you scrub when you wash your car they never seem to go away! Those red marks are referred to as paint transfers and by following these steps you can finally say, “Good Bye!”, to those unsightly blemishes.
Things You Will Need:
- Water Hose
- Water Hose Nozzle
- 5 Gallon Bucket
- Automotive Washing Soap
- Automotive Washing Brush
- Water Blade
- Drying Towels
- Automotive Clay Bar
- Automotive Clay Bar Lubricant
- Automotive Cutting Compound
- Automotive Cutting Compound Pads
- Automotive Detailing Polish
- Polish Pads
- Automotive Wax (A High Grade Acryllic Sealer Wax is Recommended)
- Automotive Wax Pads
- Microfiber Towels
STEP #1: Place enough automotive car wash soap to cover the bottom of your 5 gallon bucket and fill with water using your water hose and water hose nozzle.
STEP #2: Rinse your entire vehicle using the high pressure position on your water nozzle to rinse free any loose dirt from your vehicle.
STEP #3: Using your automotive wash brush and soap to clean your ewntire vehicle.
STEp #4: Rinse the vehicle clean of automotive soap.
STEP #5: Using your water blade, make long continuous strokes from top to bottom to remove water from the vehicle.
STEP #6: After the majority of the water from your vehicle has been removed with your water blade, use your drying towel to completely dry the extrerior of your vehicle, paying close attention to seems and joints where water collects. NOTE: not completely drying your vehicle to hinder the following processes.
STEP #7: After your vehicle has been completely dried, spray the Automotive Clay Bar lubricant generously over the paint trasnfer area. Immediately after apply the lubricant gently take the automotive detailing clay and gentley, using a back and forwth motion paying close attention not to apply any undue pressure, rub the clay onto the paint. The automotive detailing clay removes any foreign particles that may have bonded to your paint. These particles can cause scratches and swirl marks during the compounding, polishing and waxing process if not removed. After you have completed the clay bar process use your microfiber to wipe the excess lubricant from the area.
STEP #8 : Apply a small amount of automotive cutting compound to your compound pad and place onto the paint transfer area. Gently cover the entire paint transfer area with the cutting compound. After you have covered the painttransfer with cutting compound begin to make quick, circular motion with the cutting pad applying a generous amount of pressure. After the cutting compound has become semi translucent, buff off with your microfiber towel. NOTE: This process may need to be repeated if the paint transfer is still present.
STEP #9: Once the paint transfer has been removed apply a small amount of automotive detailing polish to your polish pad and with tight, circular motions apply to the compounded area until you can longer see the polish. Once you can longer see the polish buff the area with your microfiber towel.
STEP #10: After the automotive detail polish has been buffed clean, apply your wax to your wax pad and in tight, circular motions apply wax to the compounded and polished area. Once the wax has been applied and has turned to a white haze, buff the area with your microfiber pad until all the excess wax has been buffed clear.
NOTE: Generally during a professional detail the entire vehicle will have the automotive detail clay process applied to the vehicle as well as the waxing process.
Thank you for reading our Auto Detailing Blog